Perform Network Settings With Usb Connection; Configuring Wired Lan Settings - Panasonic KV-N1058X Operating Manual

15.2 Perform Network Settings with USB Connection

15.2 Perform Network Settings with USB
Connection
You can configure the network settings using Network Setting Tool with USB connection.
For details about network-related settings, consult your network administrator.

15.2.1 Configuring wired LAN settings

1.
Start Network Setting Tool.
2.
Select [Wired LAN] as the connection method for the scanner.
•
Display the current settings.
3.
Click [Date & Time], and then set the date and time.
4.
Click [Change], and then configure the following network settings.
Item
Host Name
DHCP
AutoIP
*1
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
WINS Server 1
WINS Server 2
Network Authentication
Type
When the IP address can not be acquired from the DHCP server, the following values are automatically set.
*1
•
IP Address: 169.254.1.0 - 169.254.254.255
•
Subnet Mask: 255.255.0.0
•
Default Gateway: 0.0.0.0
In this case, if the IP address has the same value as other devices, the unit can not be connected to the network. Check the DHCP
server is running correctly.
136
Set the host name for the scanner.
Enable (On) or disable (Off) DHCP.
Enable (On) or disable (Off) AutoIP. If DHCP is disabled, this setting cannot be
changed.
Set the IP address. If DHCP is enabled, the IP address will be set
automatically and cannot be changed.
Set the subnet mask. If DHCP is enabled, this will be set automatically and
cannot be changed.
Set the default gateway. If DHCP is enabled, this will be set automatically and
cannot be changed.
Set the primary DNS server. If DHCP is enabled, this will be set automatically
and cannot be changed.
Set the secondary DNS server. If DHCP is enabled, this will be set
automatically and cannot be changed.
Set the primary WINS server. If DHCP is enabled, this will be set automatically
and cannot be changed.
Set the secondary WINS server. If DHCP is enabled, this will be set
automatically and cannot be changed.
Set the network authentication type (None / PEAPv0(MSCHAPv2) / EAP-TLS).
[Next]
[OK]
[OK]
Description