Panasonic KV-N1058X Operating Manual page 159

Item
Communication
standard
Frequency range
(center
frequency) /
Channel
Data transfer
rate
Wireless LAN
Access method
Security
Wi-Fi Protected
Setup (WPS)
RF output power
The power requirements differ depending on the country/area. Do not use a power source that does not meet the power source
*1
specifications marked on the unit. The power source specifications of this unit are listed on the rating name plate.
If connected to a network device (hub, router, etc.) that supports IEEE802.3az.
*2
To assure continued emission limit compliance, use only shielded LAN cable. The cable should be a CAT 5 (Category 5) or higher
*3
for 10Base-T / 100Base-TX, or CAT 5e (Enhanced Category 5) or higher for 1000Base-T.
The actual line speed may be different depending on the network environment and the wireless devices connected.
*4
Depending on the wireless router (wireless access point) used, connections may not be possible between the unit and the wireless
*5
router. When connecting with 802.11n, select WPA-PSK (AES) or WPA2-PSK (AES) for security. Use WPA2 (AES) for security. If
WPA (AES), WPA (TKIP) or WPA2 (TKIP) must be used, please set the access point key renewal interval for 2 minutes. A difficult
to predict passkey (PSK) of 20 or more characters is recommended.
IEEE802.11n/g/b
KV-N1058X
2.412 GHz – 2.472 GHz (1 – 13ch)
KV-N1058X
KV-N1028X
2.412 GHz – 2.462 GHz (1 – 11ch)
IEEE802.11n: 6.5 – 150 Mbps
IEEE802.11g: 6 – 54 Mbps
*4
IEEE802.11b: 1 – 11 Mbps
Station mode / Simple AP mode
WPA/WPA2-PSK(TKIP/AES) / WPA/WPA2-EAP(EAP-TLS/EAP-
*5
TTLS(MSCHAPv2)/PEAPv0(MSCHAPv2)) / Open System
PBC (Push Button Configuration) method / PIN (Personal
Identification Number) method
IEEE802.11n: 13 dBm ± 1 dB
IEEE802.11g: 13 dBm ± 1 dB
IEEE802.11b: 17 dBm ± 1 dB
KV-N1058X
/ :
U ML
/ :
M B
:
M
15.14 Specifications
KV-N1028X
159