Toro LT2240 Installation Instructions Manual page 14

7. Remove the hex-head bolt (8 x 10 mm), coupling hex nut (8 mm), and washer (8 mm) from the top
of the seat arm (Figure
Retain the hex-head bolt (8 x 10 mm), coupling hex nut (8 mm), and washer (8 mm) for later installation.
Installing the Control Arm and Seat Belt to the New Air Ride Seat
1. Remove the 3 Phillips-head screws securing the seat cushion and remove the seat cushion
This allows access to secure the control arm to the seat.
2. Remove the plastic cover from the left side, loosen the bolt, and secure the seat-belt retainer using the
previously removed bolt
Apply Loctite ® 243 to the bolt and torque the bolt to 70 to 75 N∙m (52 to 55 ft-lb) and install the plastic cover.
19).
(Figure 17).
Figure 19
Figure 20
14
g345727
(Figure 20).
g344859