Toro LT2240 Installation Instructions Manual page 16

6
Installing the Seat
Model 31654
Parts needed for this procedure:
4 Locknut (8 mm)
4 Hex-head bolt (8 x 25 mm)
Procedure
1. At the bottom plate of the new seat, locate the
seat-mounting holes for your machine
22).
Figure 22
2. Assemble the 4 hex-head bolts (8 x 25 mm)
to the holes in the flange of the bottom plate
(Figure 23) that you identified in step 1.
1. Hex-head bolt (8 x 25 mm) 2. Flange (seat-bottom plate)
(Figure
3. Align the 4 hex-head bolts (8 x 25 mm) of the
new seat with the holes in the operators platform
(Figure
1. Hex-head bolt (8 x 25 mm) 3. Locknuts (8 mm)
2. Operator's platform
4. Assemble 2 locknuts (8 mm) to the bolts on the
g036928
left side of the seat.
5. Partially raise the operator's platform to access
the threads of the 2 other hex-head bolts (8 x
25 mm).
Important:
from falling.
6. Assemble the 2 locknuts (8 mm) to the other 2
hex-head bolts (8 x 25 mm) by hand.
7. Fully raise the platform.
8. Torque the hex-head bolts (8 x 25 mm) and
locknuts (8 mm) to 27 N∙m (20 ft-lb).
16
Figure 23
24).
Figure 24
Support the seat to prevent it
g345847
g345846