Toro LT2240 Installation Instructions Manual page 5

4. While supporting the seat, remove the 4 washers
(8 mm) and 4 locknuts (8 mm) that secure the
seat to the seat platform
Note:
Do not remove the 4 bolts (8 x 25 mm)
from the holes in the seat and seat platform.
Figure 7
1. Bolt (8 x 25 mm)
2. Seat platform
5. Lower the operator's platform as follows:
A. Lower the platform carefully.
B. Move the locking-latch handle toward the
front of the mower as the platform nears the
fully lowered position.
Note:
This ensures that the latch hooks
clear the locking bar.
C. Fully lower the platform and move the
locking handle toward the rear of the mower
until the latch hooks fully engage the locking
bar.
6. Remove the seat from the platform.
Note:
Discard the 4 bolts (8 x 25 mm), 4
locknuts (8 mm), and 4 washers (8 mm).
(Figure 7).
g036780
3. Locknut (8 mm)
4. Washer (8 mm)
5