Toro LT2240 Installation Instructions Manual page 20

Models 31657 and 31659
1. Connect the main wire-harness connector to
the control arm that you disconnected in
Removing the Existing Seat (page
2. Locate the connector labeled AIR-RIDE on the
seat behind the rubber boot.
Locate the air-ride seat connector on the main
wire harness breakout and install the connector.
Note:
The breakout of the main wire harness
is located by the seat.
3. Connect the seat-switch connector.
4. Remove the fuse-block cover located next to the
battery (Figure 29)
Figure 29
1. Fuse block
5. Install the new mini fuse (10 A) into the fuse
block (Figure 29).
Note:
Use the decal on the fuse-block cover for
the fuse position.
6. Install the fuse-block cover
3
6).
g328464
2. Fuse-block cover
(Figure 29).
20