3.
Locate the previously removed control arm and brackets.
4.
Secure the previously removed fasteners as shown in
5.
Apply Loctite
®
243 to the hex-head bolt (7/16 x 2 inches) and torque the hex-head bolt (7/16 x 2 inches) to
70 to 75 N∙m (52 to 55 ft-lb).
1. Control-arm support
2. Previously removed hex-head bolt
(7/16 x 2 inches)—apply Loctite 243 to
this bolt.
6.
Secure the front control arm support plate to the seat
7.
Secure the previously removed hex-head bolt (8 x 10 mm), coupling hex nut (8 mm), and washer (8 mm)
at the top of the seat arm
8.
Install the previously removed seat cushion.
Figure 21
3. Previously removed washer
4. Previously removed washer
(Figure
19).
Figure
21.
5. Previously removed seat belt
6. Previously removed spacer
(Figure
16).
15
g344019