Toro LT2240 Installation Instructions Manual page 24

Maintenance
Greasing the Seat
Suspension Mechanism
Service Interval: Yearly
1. Pull back the rubber boot from the channel of
the seat base.
2. Apply good quality grease to all pivot points of
the suspension mechanism.
3. Install the boot onto the channel of the seat
base.
Maintaining the Seat Belt
There are no field-serviceable parts on the seat belt.
If it shows signs of wear, damage, or malfunction,
replace the seat belt assembly.
Cleaning the Seat
Important:
Do not clean the seat with a pressure
washer.
Note:
Keep the surfaces of the operator's seat clean.
CAUTION
Use caution when cleaning the
backrest—unintentionally moving backrest-tilt
lever may cause the backrest to rotate forward
unexpectedly and cause injury.
When cleaning the backrest cushion, firmly
hold the backrest when operating the
backrest-tilt lever.
•
You do not need to remove the upholstery from the
seat frame for cleaning.
•
While cleaning the upholstery, do not allow
cleaning solution to soak through the upholstery
surfaces.
•
Use commercially available upholstery or plastic
cleaning solution. Before using a new cleaning
solution, test it for compatibility with the upholstery
on a small concealed area of the seat.
24