Guarantee And Support - Philips DL8740 Manual

Recyclage
- Ce symbole signifie que ce produit ne doit pas
être mis au rebut avec les ordures ménagères
(2012/19/EU) (Fig. 20).
- This symbol means that this product contains
batteries which shall not be disposed of with
normal household waste (2006/66/EC) (Fig.
21).
- Follow your country's rules for the separate col
lection of electrical and electronic products and
batteries. Correct disposal helps prevent nega
tive consequences for the environment and hu
man health.
Removing disposable batteries
To remove disposable batteries, see the instruc
tions for placing and/or removing batteries in the
user manual.

Guarantee and support

If you need information or support, please visit
www.philips.com/support or read the separate
worldwide guarantee leaflet.
If you need more information about the app,
please visit www.philips.com/healthprograms
Troubleshooting
This chapter summarizes the most common pro
blems you could encounter with the appliance. If
you are unable to solve the problem with the infor
mation below, visit www.philips.com/support for a
list of frequently asked questions or contact the
Consumer Care Center in your country.
Problem
The device
does not re
spond or re
sets automati
cally when I
pull out the
battery strip.
The thermo
meter seems
to be inaccu
rate or the
measurement
results seem
questionable.
The battery
symbol
flashes on
the display.
The display
shows Err0
The display
shows Err2
The display
shows Err3
Explanation of symbols
The warning signs and symbols are essential to en
sure that you use this product safely and correctly
and to protect you and others from injury. Below
you find the meaning of the warning signs and sym
bols on the label and in the user manual.
Possible
cause
The batteries
are empty.
The poles of
the batteries
point in the
wrong direc
tion.
The batteries
are not ma
king proper
contact.
The measu
red tempera
ture is lower
than
32.4°C/90.3°F
or higher
than
42.9°C/109.2°
F.
The device is
malfunctio
ning.
Temperature
is out of tem
perature mea
suring range.
The infrared
sensor is not
clean en
ough.
You are not
measuring
temperature
in the correct
way.
Your room
temperature
is too low or
too high.
You are using
the device
outdoors.
You have
held the de
vice in your
hand too
long.
The batteries
are empty.
Self-test er
ror
Stabilization
error
Battery level
low
Solution
Replace the batte
ries.
Remove the batte
ries and reinsert
them properly.
Remove the batte
ries and reinsert
them properly.
Follow the instruc
tions in the user
manual for proper
measurement.
Contact the Phi
lips Consumer
Care Center in
your country.
Use the thermome
ter in the range of
operating condi
tions (see 'Specifi
cations').
Clean the infrared
sensor with a cot
ton swab accor
ding to user ma
nual.
Make sure that
you have read the
user manual and
know how to use
the device proper
ly.
Use your thermo
meter at room
temperatures bet
ween 10.0°C and
40.0°C (50.0°F
and 104.0°F).
The device is only
intended for in
door use.
Put the device on
the table in the
room where the
measurement is ta
king place and let
it cool down first.
Replace the emp
ty batteries with
new ones.
Remove and re
place the batte
ries. If the error
persists, contact
Philips Consumer
Care Center in
your country .
Wait 30 minutes
and measure
again.
Replace the emp
ty batteries with
new ones.