Table of Contents
Advertisement
Display
"REMOVE PAPER IN INPUT
TRAY #2"
"REPLACE DRUM CHANGE
SUPPLIES"
"RX MEMORY FULL"
"SCANNER POSITION
ERROR"
"SERIAL ERROR"
"SUBSCRIBE TO CALLER ID"
"TONER EMPTY"
"CHANGE SUPPLIES"
"TONER LOW"
"CHANGE SUPPLIES"
"TOP COVER OPEN"
"TRANSMIT ERROR"
14.2.2 Cordless handset (KX-MB2060 optional)
Display
"Base no power"
or
"No link. Re-connect
base AC adaptor."
"Busy"
"Error!!"
"Invalid"
Cause & Solution
R The recording paper is installed in the manual input tray when trying to
receive faxes or print reports. Remove the recording paper from manual
input tray.
R The drum cartridge's service life is finished. Replace the drum cartridge and
the toner cartridge immediately.
R The memory is full of received documents due to a lack of recording paper
or a recording paper jam. Load paper (page 16) or remove the jammed
paper (page 125).
R If the PC fax (feature #442 on page 86) is set to "ALWAYS",
– check the connection between the computer and the unit.
– check that the computer is turned ON.
R If the fax preview mode (feature #448 on page 66) is set to "ON",
– view, print or save the received fax documents using the web browser
on the computer connected via the LAN, and then erase the
unnecessary documents (page 66).
– turn the setting to "OFF". The fax documents stored in memory will be
printed automatically.
R There is something wrong with the scanner position. Turn the power switch
OFF, then ON. If the problem cannot be solved, contact our service
personnel.
R There is something wrong with the unit. Contact our service personnel.
R You must subscribe to use Call Display service. Contact your service
provider/telephone company for service availability. Once you receive caller
information, this message will not be displayed.
R The toner is empty. Replace the toner cartridge immediately.
R The toner is reaching the end of its life. You will need to replace the toner
cartridge soon.
R The top cover is open. Close it.
R A transmission error occurred. Try again.
Cause & Solution
R The cordless handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Turn the base unit's power switch OFF to reset the unit. Turn the power
switch ON and try again.
R The cordless handset's registration may have been cancelled. Re-register
the cordless handset (feature #130 on page 103).
R The called unit is in use.
R Other units are in use and the system is busy. Try again later.
R The cordless handset you are using is too far from the base unit. Move closer
and try again.
R Recording was too short. Try again.
R There is no cordless handset registered to the base unit matching the
cordless handset number you entered.
R The cordless handset is not registered to the base unit. Register the cordless
handset (feature #130 on page 103).
14. Help
111
Advertisement
Table of Contents
