Table of Contents
Advertisement
For your safety
Laser radiation
R The printer of this unit utilizes a laser. Use of controls
or adjustments or performance of procedures other
than those specified herein may result in hazardous
radiation exposure.
Fuser unit
R During or immediately after printing, the fuser unit
(A) gets hot. This is normal. Do not touch the fuser
unit.
Note:
R The area near the output tray (B) may also get warm.
This is normal.
A
For best performance
Toner cartridge and drum cartridge
R When replacing the toner cartridge or drum cartridge,
do not allow dust, water, or liquids to come in contact
with the drum. This may affect print quality.
R For optimal performance, genuine Panasonic toner
cartridges and drum cartridges are recommended.
We cannot be responsible for problems that may be
caused by a non-Panasonic toner cartridge or drum
cartridge:
– Damage to the unit
– Poor print quality
– Improper operation
Toner cartridge
R Do not leave the toner cartridge out of the protective
bag for a long time. It will decrease the toner life.
Drum cartridge
R Read the instructions on page 12 before you begin
installation of the drum cartridge. After you have read
them, open the drum cartridge protective bag. The
R To extend the life of the drum cartridge, the power
Location
R To avoid malfunction, do not position the unit near
Static electricity
R To prevent static electricity damage to the interface
Environment
R Keep the unit away from electrical noise generating
R The unit should be kept free from dust, high
R The unit should not be exposed to direct sunlight.
R Do not place heavy objects on top of the unit. When
B
R The unit should be kept away from heat sources such
R Do not cover slots or openings on the base unit.
Routine care
R Wipe the outer surface of the unit with a soft cloth. Do
Important Information
drum cartridge contains a photosensitive drum.
Exposing it to light may damage the drum. Once you
have opened the protective bag:
– Do not expose the drum cartridge to light for more
than 5 minutes.
– Do not touch or scratch the black drum surface.
– Do not place the drum cartridge near dust or dirt,
or in a high humidity area.
– Do not expose the drum cartridge to direct
sunlight.
switch should never be turned OFF immediately after
printing. Leave the power turned ON for a minimum
of 30 minutes after printing.
appliances such as TVs or speakers which generate
an intense magnetic field.
connectors or other electrical components inside the
unit, touch a grounded metal surface before touching
the components.
devices, such as fluorescent lamps and motors.
temperature and vibration.
you leave the unit unused for a long period of time,
unplug this unit from the power outlet.
as heaters, kitchen stoves, etc. Damp basements
should also be avoided.
Inspect the air circulation vents regularly and remove
any dust build-up with a vacuum cleaner (A).
A
not use benzine, thinner, or any abrasive powder.
A
3
Advertisement
Table of Contents
