Toshiba e-STUDIO163 Service Manual page 106
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO163:
- Service handbook (235 pages) ,
- Service manual (222 pages) ,
- Operator's manual (162 pages)
Table of Contents
Advertisement
(3)
Take off the CIS unit drive belt-1.
Note:
When assembling the CIS unit drive belt-1,
assemble it while the fixing screw is loos-
ened. Then tighten the fixing screw of the
tension bracket.
[I]
CIS unit drive belt-2
(1)
Take off the scanner top cover.
P.6-13 "[B] Scanner top cover"
(2)
Take off the right rear cover.
P.2-22 "[I] Right rear cover"
(3)
Take off the CIS unit drive belt-1.
P.6-19 "[H] CIS unit drive belt-1"
(4)
Loosen 2 fixing screws of the scan motor.
(5)
Take off the CIS unit drive belt-2.
Note:
When assembling the CIS unit drive belt-2,
be sure to perform the tension adjustment for
the scan motor.
P.6-13 "[C] Scan motor (M1)"
e-STUDIO163/203
SCANNER
CIS unit drive belt-2
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
6 - 20
Fig. 6-30
Scan motor
Fig. 6-31
Fig. 6-32
Advertisement
Table of Contents
