Toshiba e-STUDIO163 Service Manual page 221

[I] Center thermistor / Side thermistor / Edge thermistor (THMS1/THMS2/THMS3)
(1) Take off the fuser roller.
P.13-17 "[G] Fuser roller"
(2) Remove each 1 screw of the thermistors,
and then take off each thermistor by releas-
ing its harness out of the harness clamp.
Note:
When installing the thermistors, do not mix
up the installation positions of the side ther-
mistor and the edge thermistor by telling
them apart by the length of their harnesses.
[J] Fuser thermostat (THMO1)
(1) Take off the fuser roller.
P.13-17 "[G] Fuser roller"
(2) Remove 2 screws and take off the fuser ther-
mostat.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Thermistor
Fig. 13-30
Side thermistor
Center thermistor
Fig. 13-31
Fig. 13-32
13 - 19
Edge thermistor
Fuser thermostat
e-STUDIO163/203
FUSER / EXIT UNIT
13