Table of Contents
Advertisement
MicroMAS Recovery
In the event that MicroMAS suffers a catastrophic failure the following procedures will restore the
MicroMAS to the configuration it was in when shipped. If possible backup the data, configuration
and license files before starting. At the conclusion of these steps return to the MicroMAS Software
Setup section of this chapter.
Important!
The MicroMAS Recovery procedure MUST be followed completely. Do not stop until
the procedure is complete.
Step 1A: Restore Using the Recovery CD Set
1. Ensure that the LAN cable from the LAN connector on the MicroMAS is NOT connected.
Important!
Ensure that the MicroMAS does NOT have internet access at this time.
2. Connect power cable to your MicroMAS server and power up the server.
3. Power up the MicroMAS by setting the AC Input Switch of the power supply, then press the
Power Switch on the front panel.
4. Insert the Recovery CD number one into the CD-ROM Drive.
(Note: DO NOT remove this CD until instructed to insert another CD-ROM.)
5. Restart the MicroMAS by pressing Ctrl-Alt-Delete or by powering the unit Off and then On
again. The computer will boot from the CD into the recovery environment.
Note
Until the recovery is complete the mouse will not function.
6. A dialog box will appear asking: Do you want to recover? Press the Y key on the keyboard to
answer yes. A Caution dialog box stating that All data on the hard drive will be lost. Press the
Y key on the keyboard.
The Clearing Hard Disk Drive box will appear. Then the Toshiba - Symantec status screen will
appear.
7. The screen prompt: Please insert the CD in order to continue the process. Remove CD one,
insert CD two then press ENTER.
8. When the screen prompts: Please insert the CD in order to continue the process. Remove CD
two, insert CD three then press ENTER.
9. At the end of the process the following will display. Recovery of Pre-installed Software is
completed. Please remove the CD-ROM or floppy disk. Press any key and restart the system.
10. Remove the CD-ROM from the drive then, press any key on the keyboard. The MicroMAS will
restart.
Step 1B: Setup for Windows Mini-Setup Wizards
1. In the Welcome to the Windows XP Setup screen, click on Next.
2. In License Agreement screen, check the I accept the agreement box then click Next
3. In Regional and Language option, leave everything default, then click Next.
4. In the Personalize Your Software screen enter admin as the name and your company name
then click Next
5. Enter the 25 characters Product Key which can be found on the label on the top cover of the
MicroMAS chassis.
6. For computer name enter: MICROMAS01 or a computer name that is unique to the network.
For password enter password
Micro MAS Installation Guide
4/07
MicroMAS Installation Guide
MicroMAS Recovery
19
Advertisement
Table of Contents
