Step 4: Remove Cover - Toshiba MicroMAS Installation Manual

Step 4: Remove Cover

1. Once the unit is operational, shut down Windows, turn the power off and remove the power
cable.
2. Remove the two screws from the upper left and right corners of the back of the server. Pull the
cover off using the build-in handle.
Step 5: Unpack Voice / Fax-modem Boards
Unbox the Dialogic voice (Dialogic part number D4PCIUF/S) and/or MultiTech System Fax-
modem (MultiTech part number MT5634ZPX-PCI) board(s) to be installed in this system.
Note MicroMAS only supports half-length PCI boards.
Step 6: Install Voice/Fax
Board(s)
1. Loosen the riser retaining bar by pulling
on the release tab and lifting the Bar to
unlock it (shown right).
2. Remove the PCI riser screw, then
remove the PCI riser by pulling the riser
upwards with the green strap.
3. Insert the edge connector of the first
board into the PCI 1 slot (see
Apply pressure only to the top edge of
the board, and gently rock the board
back and forth to seat the edge
connector into the slot.
4. Insert the second board into the PCI 2
slot.
Note A Dialogic Voice board can be installed in the PCI 1 (top) slot with no modification. To
install a fax-Modem card into the PCI 1 card slot the green strap must first be removed
from the riser. The fax-modem card can be installed in the PCI 2 slot without modification.
PCI Riser
Figure 2 MicroMAS Internal View 2
Micro MAS Installation Guide
Figure 2).
002-MM
4/07
Retaining Bar
Release Tab
Figure 1 MicroMAS Internal View 1
MicroMAS Installation Guide
Installation
001-MM
Riser
Power Supply
Retaining Bar
PCI 1 Card
PCI 2 Card
CPU Fan
RAM Slot
Chassis Fan
3