Table of Contents
Advertisement
2. Remove the system cover.
Steps
1. Unroute the cable and remove the screw that secures the USB module on the system.
2. Push the cable and disconnect it from the system.
3. Remove the front USB module from the system.
Installing front USB module
Steps
1. Place the front USB module in the slot on the system.
2. Connect and slide the USB module cable and tighten the screw.
3. Route the cable through the routing channel.
Next steps
1. Install the system cover.
2. Install the front bezel.
Internal USB memory key (optional)
Replacing optional internal USB memory key
Steps
1. Locate the USB connector or USB key on the system board.
2. If installed, remove the USB key.
3. Insert the new USB key into the USB connector.
Next steps
1. While booting, press <F2> to enter the System Setup and verify that the USB key is detected by the system.
Disassembly and reassembly
59
Advertisement
Table of Contents
