Table of Contents
Advertisement
b. Internal USB key (if applicable)
c. USB 3.0 module
d. vFlash card
e. Optical drive
f. All expansion card risers
g. Processor and heat sink module
h. Processor and memory blank
i.
Memory modules
j.
Cooling fan assembly
k. Air shroud
l.
Power supply unit(s)
3. Reconnect all cables to the system board.
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
NOTE:
bracket.
4. The Easy Restore feature restores several configuration settings, most notably the Service Tag, iDRAC Licenses, and OEM
ID Modules (if needed for the last two). Refer to the Restoring the Service Tag Using Easy Restore page. When the system
board is booted for the first time it will present a screen with settings it can restore.
If for any reason Easy Restore does not execute, you must enter the service tag manually. Refer to the Update
NOTE:
the Service Tag page. Other configuration issues must also be done manually, for instance importing iDRAC License
through iDRAC GUI
5. Import your new or existing iDRAC Enterprise license. For more information, see Integrated Dell Remote Access Controller
User's Guide, at Dell.com/esmmanuals.
6. Ensure that you:
a. Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy restore section.
b. If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see
the Entering the Service Tag section.
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the Trusted Platform Module
(TPM) section.
Trusted Platform Module
Replacing the Trusted Platform Module
Prerequisites
CAUTION:
Do not attempt to remove the Trusted Platform Module (TPM) from the system board. Once the TPM
is installed, it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM
breaks the cryptographic binding, and it cannot be re-installed or installed on another system board.
This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell
NOTE:
certified service technicians.
There is a TPM slot on the system board of each sled.
NOTE:
Steps
1. Locate the TPM connector on the system board.
To locate the TPM connector on the system board, see the System board connectors section.
NOTE:
2. Align the edge connectors on the TPM with the slot on the TPM connector.
3. Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.
4. Press the plastic rivet until the rivet snaps into place.
Disassembly and reassembly
63
Advertisement
Table of Contents
