NOTE
• When a communication line error has occurred, reset cannot be made from the network.
• The inverter is set to the External operation mode if it has been reset in Network operation mode in the initial status.
To resume the network operation, the inverter must be switched to the Network operation mode again.
Set a value other than "0" in Pr.340 to start in the Network operation mode. (Refer to
• Communication continues during inverter reset. The inverter cannot be controlled for about 1 s after release of a reset
command.
• Refer to
page 84
46
INVERTER SETTING
for an inverter reset program example.
page
36.)