Cleaning / Maintenance Intervals - Sharp MAX-PRO 1182 Operator's Manual

DAILY CLEANING / MAINTENANCE
•
Inspect the Bag Edge Present Sensor. Clean
as needed. See
Cleaning Procedure, page 2-7.
•
Inspect the Teflon
Sensing Jaw. Tape should be free from resi-
due of film or ribbon. Replace as needed.
•
Inspect all air lines and electrical wires for any
sign of damage. Replace worn or damaged
lines or wires.
WEEKLY CLEANING / MAINTENANCE
•
Inspect the rubber Drive and Platen Rollers.
Clean as needed. See
ers Cleaning Procedure, page 2-8.
•
Verify the Driver Roller Assembly moves freely
with power removed.
•
Inspect the aluminum Pinch Roller. Clean as
needed. See Pinch Roller Cleaning Proce-
dure, page 2-8.
•
Verify the Pinch Roller spins freely when latch
is opened.
•
Inspect the Seal Bar. Clean as needed. See
Seal Bar Cleaning
•
Inspect the rubber Unwind Drive Roller. Clean
as needed. See
Procedure, page 2-10.
•
Verify the Unwind Driver Roller Assembly
moves freely with power removed.
•
Inspect the Unwind Pinch Roller. Clean as
needed. See Unwind Pinch Roller Cleaning
Procedure, page 2-10.
•
Verify the Pinch Roller spins freely when latch
is opened.
•
Inspect the Teflon
sure Bar Anvil Rubber and replace if worn or
damaged.
MONTHLY CLEANING / MAINTENANCE
•
All of Weekly maintenance.
MAX-PRO Operator Manual

CLEANING / MAINTENANCE INTERVALS

Bag Edge Present Sensor
®
Tape on the Obstruction
Drive and Platen Roll-
Procedure, page 2-9.
Unwind Drive Roller Cleaning
®
Tape that covers the Pres-
SECTION 3 - SET-UP & OPERATION
•
Inspect the Air Filter for debris and replace as
necessary.
•
Inspect all external wiring for loose connec-
tions and wear. Tighten any loose connec-
tions and replace any worn cables.
SEMI - ANNUAL CLEANING / MAINTENANCE
•
All of Weekly and Monthly maintenance.
•
Inspect the Linear Guide Bearings located on
the Pressure Bar Guide Shafts for wear and
replace as needed.
•
Inspect the Linear Guide Bearings located on
the Sealer Assembly Guide Shafts for wear.
Replace as necessary.
ANNUAL CLEANING / MAINTENANCE
•
All of Weekly, Monthly, and Semi-Annual
maintenance.
•
Inspect entire machine for loose hardware.
•
Inspect all air lines for any sign of wear or
damage. Replace any lines that appear worn
or damaged.
•
Inspect all wires and cables for any sign of
wear, damage, or loose connections. Tighten
any loose connections and replace anything
that appears worn or damaged.
•
Inspect all Drive Belts for wear and proper
tension. Replace any belts that appear to be
worn or damage.
3-10
Original Printed in English