Table of Contents
Advertisement
Fault
Seal Bar not at Temperature -
Bagger inhibited from cycling
Low Pressure Air Timed Out
Recovery Mode Active
Recovery Mode Feeding New Bag
Bag Is Filled
Bag Level Low
Demo Mode Is Active
Factory Test Mode Is Active
Machine Not Tested
Printer Not Ready
Printer Ribbon Low
Waiting For Printer
Printer Ribbon
MAX-PRO Operator Manual
BAGGER/PRINTER WARNINGS
Cause
Seal Bar is not at the required tem-
perature for sealing.
Low Pressure Air Timed Out
Attempting to open the bag again.
The bagger is feeding out a replace-
ment bag. It could not open the orig-
inal bag.
A bag has been filled and sealed in
Filler Mode.
Bag are getting low in box.
Bagger's demo mode is active.
Bagger is running in Test Mode.
Bagger life cycle count is not over
1,000 cycles .
Waiting for printer to begin bagging. Load label into printer.
Printer ribbon is nearly at minimum
usage.
Waiting for the printer to print before
finishing the bagging cycle.
Ribbon not moving during print
4-3
FAULT & ALERT MANAGEMENT
Bagger will not cycle until required
temperature has been reached.
No intervention required by opera-
tor.
No action is required.
No action is required.
No action is required.
Prepare to replace bags soon.
Disable demo mode in Set-
tings\Demo to turn off this warning.
Turn Factory Test OFF in Factory
Setup\Factory Test.
Bagger has to run continuously for
1,000 cycles without a fault to clear.
Prepare to replace ribbon.
Load label into printer.
Verify ribbon is installed correctly.
Possible Solution (S)
Original Printed in English
Advertisement
Table of Contents
