Huawei TaiShan 200 Product White Paper page 12

TaiShan 200 Server
White Paper (Model 2180)
Table 4-3 Ports on the rear panel
Port
VGA port
USB port
Management
network port
Serial port
GE electrical
port
PSU socket
Issue 02 (2020-06-22)
● I/O module 1 can be configured with a rear drive module with two 2.5-inch drives or a
PCIe riser module (PRM). I/O module 2 can be configured with a rear drive module with
two 2.5- or 3.5-inch drives. I/O module 3 cannot be used. The preceding figure is for
reference only.
● FlexIO can be a TM210 NIC.
● FlexIO is not hot-swappable. If you need to replace it, power off the server.
Type
DB15
USB 3.0
RJ45
RJ45
RJ45
-
Copyright © Huawei Technologies Co., Ltd.
Quantit Description
y
1 The VGA port is connected to a
terminal, such as a monitor or
physical KVM.
2 The USB ports allow USB devices to
be connected to the server.
NOTE
Before connecting an external USB
device, check that the USB device
functions properly. A server may operate
abnormally if an abnormal USB device is
connected.
1 This 1000 Mbps Ethernet port is
used for server management, and
supports 10/100/1000 Mbps auto-
negotiation.
1 The serial port is used as the system
serial port by default. You can set it
as the iBMC serial port by using the
iBMC command. This port is used
for debugging.
4 One FlexIO provides four GE
electrical ports.
1/2 Determine the number of PSUs
based on actual requirements, but
ensure that the rated power of the
PSUs is greater than that of the
server. You are advised to configure
two PSUs to ensure reliable device
operating. When one PSU is used,
Predicted PSU Status cannot be set
to Active/Standby on the iBMC
WebUI.
4 Hardware Description
9