Calibration; Factory Settings - ABB AV410 User Manual

7 CALIBRATION

Note. An AV400 System is supplied factory-configured as a matched system with each component bearing the same serial
number. If any part of a system is replaced (transmitter or sensor[s]),

7.1 Factory Settings

Section 7.1, Page 42
FACTORY SETTINGS
Use the Menu
Key to scroll
through
the Menus
To
OPERATING PAGE
Factory Cal. B
B:Fill Zero Sol.
B: 100%
B: Fill Sol. 1
B: 100%
B: Fill Sol. 2
B: 100%
B: Fill Sol. 3
B: 100%
B:Cal. Complete
Key
Dual input analyzers only
Use the Sidescroll Key to scroll through the Pages within each Menu
Factory Set Code Set Up Sensor A
A: Lo Organics
A:Ref. Factor
A:Ref. Low Limit
Use the Downscroll
Key to scroll through
the Parameters
within each Page
Cal. Output 1 Cal. Output 2
O1: Adjust 4mA O2: Adjust 4mA
O1: Adjust 20mA O2: Adjust 20mA
Fig. 7.1 Overall Factory Settings Chart
a complete factory re-calibration must be carried out
Set Up Sensor B Factory Cal. A
B: Lo Organics A:Fill Zero Sol.
B:Ref. Factor A:
B:Ref. Low Limit
A: Fill Sol. 1
A:
A: Fill Sol. 2
A:
A: Fill Sol. 3
A:
A:Cal. Complete
Digital Comms. Alter Fact. Code
Note. The
Digital Comms.
if the digital communications option board is fitted.
.
100%
100%
100%
100%
frame is displayed only
43