Mitsubishi Electric 800 Series Installation Manualline page 31

(2) Insert wires into a blade terminal, then crimp the terminal.
Insert wires to a blade terminal, and check that the wires come out for about 0 to 0.5 mm from a sleeve.
Check the condition of the blade terminal after crimping. Do not use a blade terminal of which the crimping is
inappropriate, or the face is damaged.
l Blade terminals commercially available (as of May 2016)
Cable gauge (mm²)
With insulation sleeve
0.3 AI 0,34-10TQ
0.5 AI 0,5-10WH
0.75 AI 0,75-10GY
1 AI 1-10RD
1.25, 1.5 AI 1,5-10BK
0.75 (for two wires) AI-TWIN 2×0,75-10GY
Blade terminal product
Cable gauge (mm²)
number
0.3 to 0.75 BT 0.75-11
(3) Insert the wires into a socket.
l Wire removal
Pull the wire while pushing the open/close button all the way down firmly with a flathead screwdriver.
CAUTION
l Pulling out the wire forcefully without pushing the open/close button all the way down may damage the terminal block.
l Use a small flathead screwdriver (tip thickness: 0.4 mm / tip width: 2.5 mm).
If a flathead screwdriver with a narrow tip is used, terminal block may be damaged.
Commercially available products (as of April 2019)
Name Model
Driver SZF 0– 0,4 x 2,5
l Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause an inverter damage or injury.
Damaged
Blade terminal model
Without insulation
sleeve
—
—
A 0,75-10
A 1-10
A 1,5-10
—
Insulation product
number
VC 0.75
When using a single wire or stranded wires without a blade terminal, push
the open/close button all the way down with a flathead screwdriver, and
insert the wire.
Open/close button
Flathead screwdriver
Manufacturer
Phoenix Contact Co., Ltd.
Wires are not inserted
Crumpled tip
into the sleeve
Manufacturer Crimping tool name
Phoenix Contact Co., Ltd. CRIMPFOX 6
Crimping tool product
Manufacturer
number
NICHIFU Co.,Ltd. NH 69
Open/close button
Flathead screwdriver
WIRING
Unstranded
wires
25