Mitsubishi Electric 800 Series Installation Manualline page 43

No. Component
J
K
L
M
N
O
*1
Situations such as when the MRS/X10 signal is input, during the automatic restart after instantaneous power failure, after auto tuning
is complete, when "SE" (incorrect parameter setting) alarm occurs.
Name Description
Switches the operation panel to a different mode.
The easy setting of the inverter operation mode is enabled by pressing this key
simultaneously with the PU/EXT key.
MODE key
Every key on the operation panel becomes inoperable by holding this key for 2
seconds. The key inoperable function is invalid when Pr.161 = "0 (initial setting)".
(refer to Instruction Manual (Function))
Confirms each selection.
When this key is pressed during inverter
operation, the monitor item changes.
SET key
(The monitor item on each screen can be
changed according to the settings of
Pr.52, Pr.774 to Pr.776.).
Start command
RUN key
The direction of motor rotation depends on the Pr.40 setting.
Stops the operation commands.
STOP/RESET key
Used to reset the inverter when the protective function is activated.
UP/DOWN key Used to change the setting of frequency or parameter.
USB connector FR Configurator2 is available by USB connection.
BASIC OPERATION
Initial setting in the monitor mode
Output Output
frequency current
Output
voltage
37