Compliance With The Emc And Low Voltage Directives; Product Configuration - Mitsubishi Electric Melsec Q Series User Manual

Compliance with the EMC and Low Voltage Directives

(1) For programmable controller system
To configure a system meeting the requirements of the EMC and Low Voltage Directives when
incorporating the Mitsubishi programmable controller (EMC and Low Voltage Directives compliant)
into other machinery or equipment, refer to QCPU User's Manual (Hardware Design, Maintenance
and Inspection).
The CE mark, indicating compliance with the EMC and Low Voltage Directives, is printed on the
rating plate of the programmable controller.
(2) For the product
For the compliance of this product with the EMC and Low Voltage Directives, refer to Section 7.5
Wiring.
In addition, attach ferrite cores to power line of power supply module.
Ferrite cores used in our testing is below.
KITAGAWA INDUSTRIES CO.,LTD.、RFC-10
(3) CE marking conformity combination module
This module conforms to CE marking standard in a condition to make combination use with
following current censor and cable.
current censor
cable or
current censor cable
Max. cable length

Product configuration

The following describes the product configuration.
Model name
QE81WH
EMU-CT50, EMU-CT100,
EMU-CT250, EMU-CT400, EMU-CT600,
EMU-CT400-A, EMU-CT600-A
CE marking cable (twisted pair cable )
Single wire:
AWG24 to AWG17 (φ0.5 mm to 1.2 mm)
Stranded wire:
AWG20 to AWG16 (0.5 mm
50m
Energy Measuring Module
to 1.3 mm )
2 2
Product name
A - 8
EMU2-CT5
EMU2-CB-Q5A
EMU2-CB-T1M, EMU2-CB-T5M
EMU2-CB-T10M, EMU2-CB-T1MS
EMU2-CB-T5MS, EMU2-CB-T10MS
11m
Quantity
1