•
In the rear holes, use a bolt (M12 x 100 mm), 2
washers (M12), and a locknut (M12).
•
If your machine has a third washer included with
each bolt, use those washers as spacers between
the hitch and the inside of the hitch pivot bracket
(Figure
6).
Note: Use the holes in the hitch pivot bracket to
match the hitch height of the tow-vehicle hitch.
Figure 5
1. Hitch
2. Hitch pivot bracket
3. Washer—M10 (2)
4. Bolt (M10)
5. Washer—M12 (2)
6. Bolt (M12)
7. Locknut (M12)
8. Locknut (M10)
1. Spacer washers
3. Tighten the small bolt to 73 N∙m (54 ft-lb) and the
large bolt to 126 N∙m (93 ft-lb).
4. Push up on the hitch assembly until the latch lever is
unlocked from the slide detent
1. Latch lever
5. Pull the hitch down.
6. Step on the hitch pedal until the hitch locks into place
(Figure
8).
12
Figure 6
(Figure
7).
Figure 7