Premaintenance Procedures; Lubrication; Lubricating The Drive-Roller Bearing - Toro GreensPro 1260 Operator's Manual

Premaintenance
Procedures
The performance of certain maintenance, adjustments, or
repair operations will be determined by the owner's facilities.
Do not tilt the machine unless it is necessary. If you tilt
the machine, there is a risk that engine oil can enter the
cylinder head of the engine, and hydraulic fluid can leak from
the cap located on top of the tank. These leaks may result
in expensive repairs to the machine. For the purpose of
under-deck servicing, lift the machine with a hoist or a small
crane.

Lubrication

Lubricating the Drive-Roller
Bearing
Service Interval: Before each use or daily (lubricate
immediately after washing).
Grease Type: No. 2 lithium grease
1. Wipe the area clean so that foreign matter cannot be
forced into the bearing.
2. Pump grease into the grease fitting as shown in
30.
3. Wipe up any excess grease.
Important: After greasing, run the machine off
the turf somewhere briefly to disperse any excess
lubricant, to avoid damaging the turf.
28
Figure 30
Figure