Table of Contents
Advertisement
1-6
4.
Once the UNIVERGE WL Operating System code download is successful,
the AP reboots. The GREEN LED turns on and the two YELLOW/AMBER/
ORANGE LEDs indicate the states of the 802.11a and 802.11b/g
networks. If any part of the network is disabled in the UNIVERGE WL
Wireless Controller, the corresponding YELLOW/AMBER/ORANGE LED
remains off.
-
Note that the Red LED can light for a short period (10-20
seconds) when the AP reboots. If the RED LED comes on AND
STAYS ON for more than a minute, disconnect the AP and call
NEC Technical Support.
-
From the CLI, Web Browser or WLCS interface, configure the AP
with its Primary UNIVERGE WL Wireless Controller name.
-
If you will be using the AP in a mobility group, set the mobility
group name using the CLI, Web Browser or WLCS interface.
-
If required, use the CLI, Web Browser or WLCS interface to
customize the AP-specific 802.11a, 802.11b and 802.11g
network settings. Once again, the two YELLOW/AMBER/ORANGE
LEDs indicate the states of the 802.11a and 802.11b/g
networks. If any part of the network is disabled, the
corresponding YELLOW/AMBER/ORANGE LED remains off.
5.
If everything works (the GREEN LED is on and the RED LED is off),
disconnect the AP and take it to its final destination and install it as
described in this document. If your UNIVERGE WL AP fails this visual
test, refer to the RMA Procedures located in the UNIVERGE WL Product
Documentation to return your UNIVERGE WL APs.
6.
When you have installed and powered up the AP in its final destination,
verify that the LEDs are in the same state they were in at the end of
Step 4. If no LEDs are on, the AP is most likely not receiving power. If
the LEDs blink sequentially back and forth for more than five minutes,
the AP is unable to find its Primary UNIVERGE WL Wireless Controller.
Check the connection between the AP and the UNIVERGE WL Wireless
Controller, and make sure the AP and the UNIVERGE WL Wireless
Controller are either on the same subnet or that the AP has a route back
to its Primary UNIVERGE WL Wireless Controller. If the UNIVERGE WL
AP or UNIVERGE WL 1200R is not on the same subnet as the UNIVERGE
WL Wireless Controller, make sure there is a DHCP server on the same
subnet as the UNIVERGE WL AP or UNIVERGE WL 1200R. Also, make
sure that the route between the UNIVERGE WL AP or UNIVERGE WL
1200R and the UNIVERGE WL Wireless Controller can process IP frag-
mented packets.
After you have prepared all UNIVERGE WL APs, reconfigure the UNIVERGE WL
Wireless Controller so it is not the Master. A Master UNIVERGE WL Wireless
Controller should only be used for configuring UNIVERGE WL APs and not in a
working network.
After completing
Step 2: Configuring the UNIVERGE WL AP or UNIVERGE WL
1200R Before Installation
continue with
Step 3: Preparing Mounting
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
for all UNIVERGE WL APs and UNIVERGE WL 1200Rs,
Locations.
Advertisement
Table of Contents
