UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
Note that the UNIVERGE WL System supports Antenna Sectorization, which can
be used to increase the number of clients and/or client throughput in a given air
space. Installers can mount two UNIVERGE WL APs back-to-back and the
UNIVERGE WL System operator can disable the second antenna in both
UNIVERGE WL APs to create a 360-degree coverage area with two sectors.
The UNIVERGE WL APs can be mounted in one of four configurations:
•
Ceiling Mount Base
•
Ceiling-Mount Clips
•
Projection Wall Mount
•
Flush Wall Mount
Ceiling Mount Base
When you are mounting the UNIVERGE WL AP in the middle of a ceiling (flat
sides toward the room or hallway), use the ceiling-mount base to mount the
UNIVERGE WL AP as shown in the following figure and as described below:
Figure -
Assembling the UNIVERGE WL AP and Ceiling-Mount Base
•
Copy the MAC address(es) from the label(s) on the UNIVERGE WL AP
onto the corresponding location on the map. MAC addresses have the
format 000B85xxxxxx.
Ceiling Mount Base
1-15