Alternate Preparing A Version 2.0 Univerge Wl Ap Or Univerge Wl 1200R - NEC UNIVERGE WL Quick Installation Manual

Access point (external-antenna)
Table of Contents

Advertisement

1-10
NOTE
After completing
Step 2: Configuring the UNIVERGE WL AP or UNIVERGE WL
1200R Before Installation
continue with
Step 3: Preparing Mounting
Alternate Preparing a Version 2.0 UNIVERGE WL AP or
UNIVERGE WL 1200R
If your UNIVERGE WL AP has UNIVERGE WL Operating System 2.0 or a later
version (which includes all UNIVERGE WL 1200Rs) loaded on it, you may choose
to use this procedure. If your AP has UNIVERGE WL Operating System 1.2 or
earlier loaded on it, or if you do not know what version the AP has loaded, use
the
Preparing a Version 1.2 UNIVERGE WL AP
This procedure assumes that you are preparing a version 2.0 UNIVERGE
WL AP or UNIVERGE WL 1200R to inter-operate with a version 2.0
UNIVERGE WL Wireless Controller. It also assumes that your UNIVERGE
WL Wireless Controller is already operating in LWAPP Layer 3 Mode. It
also assumes that you are using the Internet Software Consortium (ISC)
DHCP Server V3.0pl1. Finally, it assumes that if you have deployed
multiple UNIVERGE WL Wireless Controllers, that the UNIVERGE WL
Wireless Controller you use to initialize the UNIVERGE WL AP is in a
Mobility Group with the Primary UNIVERGE WL Wireless Controller you
want to assign to the new UNIVERGE WL AP or UNIVERGE WL 1200R.
When you are preparing a version 1.2 UNIVERGE WL AP to inter-operate with a
version 1.2 UNIVERGE WL Wireless Controller, use the procedure found in the
version 1.2 UNIVERGE WL Access Point Quick Installation Guide.
Configuration Setup
Does My AP Qualify for this Procedure?
If your 2.0 or later version later UNIVERGE WL AP(s) or UNIVERGE WL
1200R(s) cannot be configured for any reason using the following
procedure, refer to the RMA Procedures located in the UNIVERGE WL
Product Documentation.
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
for all UNIVERGE WL APs and UNIVERGE WL 1200Rs,
Locations.

Alternate Preparing a Version 2.0 UNIVERGE WL AP or UNIVERGE WL 1200R

procedure above.
Configuration Setup
Does My AP Qualify for this Procedure?

Advertisement

Table of Contents
loading

Table of Contents