Table of Contents
Advertisement
NOTE
NOTE
NOTE
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
Refer to the following sections to install the UNIVERGE WL APs.
When mounting UNIVERGE WL APs and UNIVERGE WL 1200Rs, make sure
to maintain a 20 cm (8 in.) separation between the UNIVERGE WL APs or
UNIVERGE WL 1200Rs and bystanders to comply with FCC RF exposure
regulations. Refer to the
for more information.
For more details about UNIVERGE WL AP and UNIVERGE WL 1200R installations,
refer to the
Planning Notes
Step 1: Collecting Required Tools and Supplies
Step 1: Collecting Required Tools and Supplies
•
One UNIVERGE WL AP or UNIVERGE WL 1200R per location.
•
UNIVERGE WL AP and UNIVERGE WL 1200R Mounting Kits, factory-
supplied with each UNIVERGE WL AP.
•
Optional UNIVERGE WL AP and UNIVERGE WL 1200R Mounting Kits,
factory-orderable.
•
Optional external AC-to-DC power supplies, factory-orderable.
•
Optional external 802.11b/g antennas.
Refer to the UNIVERGE WL System Release Notes for 802.11a external
antenna information. Contact NEC Corporation for a list of approved
802.11a and 802.11b/g external antennas.
•
Map showing UNIVERGE WL AP and UNIVERGE WL 1200R locations, and
mounting and power options.
•
Screwdrivers, drills, and ladder.
•
An assortment of sheet metal and drywall screws and toggle bolts.
•
CAT-5 (or higher) cables to connect the UNIVERGE WL AP and
UNIVERGE WL 1200R locations and the UNIVERGE WL Wireless
Controller or other network device.
•
Optional Kensington MicroSaver Security Cable to secure each
UNIVERGE WL AP and UNIVERGE WL 1200R.
Continue with
Step 2: Configuring the UNIVERGE WL AP or UNIVERGE WL
1200R Before
Installation.
Step 2: Configuring the UNIVERGE WL AP or
UNIVERGE WL 1200R Before Installation
or UNIVERGE WL 1200R Before Installation
The following procedures are designed to make sure that your UNIVERGE WL AP
physical installation goes smoothly and that initial operation is as expected. If
you are unable to prepare your UNIVERGE WL AP for deployment, this Step also
describes RMA (Return Material Authorization) procedures.
Perform either of the following two procedures on each UNIVERGE WL AP
or UNIVERGE WL 1200R BEFORE deploying the UNIVERGE WL AP or
UNIVERGE WL 1200R in its final location.
•
Preparing a Version 1.2 UNIVERGE WL AP
2.0 UNIVERGE WL System
FCC Statements for UNIVERGE WL APs
section at the end of this document.
section
Step 2: Configuring the UNIVERGE WL AP
for installation in a Version
1-3
Advertisement
Table of Contents
