Table of Contents
Advertisement
1-20
NOTE
Flush Wall Mount
When you are mounting the UNIVERGE WL AP against a wall (flat side toward
the inside of the building), use an optional factory-orderable flush-mount
bracket.
•
Before proceeding, gently screw the two factory-supplied screws and
spring washers into the bottom of the UNIVERGE WL AP. Make sure the
spring washers have their convex (high center sections) pointing toward
the screw heads.
The UNIVERGE WL AP threaded holes have precision-depth threads. Do
not overtighten the screws, or the bracket will not fit under the screw
heads.
Figure -
Assembling the Mounting Screws and Spring Washers to the UNIVERGE
WL AP
•
Copy the MAC address(es) from the label(s) on the UNIVERGE WL AP
onto the corresponding location on the map. MAC addresses have the
format 000B85xxxxxx.
•
You have already attached the flush-mount bracket to the wall in
Step 3: Preparing Mounting
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
Flush Wall Mount
Locations.
Advertisement
Table of Contents
