Table of Contents
Advertisement
NOTE
NOTE
NOTE
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
•
Slide the screws into the keyhole slots on the mounting bracket as
shown in the following figure.
If the screws do not securely hold the bracket, remove the UNIVERGE WL
AP and adjust the screws until they securely hold the bracket.
Figure -
Assembling the UNIVERGE WL AP to the Projection-Mount Bracket
•
Attach the cables to the sides of the UNIVERGE WL AP.
Make sure the cables are routed away from the UNIVERGE WL AP
antennas.
When the UNIVERGE WL AP is powered up and is associated with an
UNIVERGE WL Wireless Controller (Green/Power and Yellow/802.11b/g
and/or Yellow or Amber/802.11a LEDs lit), the UNIVERGE WL AP begins
broadcasting its beacon signal(s). When this happens, complete the
installation as quickly as possible to remove yourself from within 8 inches
(20 cm) of the UNIVERGE WL AP to comply with FCC RF radiation
exposure guidelines.
You have installed the UNIVERGE WL AP. Repeat
UNIVERGE WL APs
for each UNIVERGE WL AP location, and then continue with
Step 5: Returning MAC
Information.
Step 4: Mounting the
1-19
Advertisement
Table of Contents
