Preparing For Installation - Panasonic Aquarea WH-ADC0309J3E5 Planning And Installation Manual

► Adhere to the prescribed sequence of installation steps.
► Only use parts and tools delivered with the equipment or as specified.
► As far as possible, avoid installation of outdoor units and mono-bloc devices near the
sea, in regions with a high content of sulphur or at sites where large quantities of oil (e.g.
machine oil, etc.) are present, as this may result in shortened operating life.
6.2

Preparing for installation

Read the following sections carefully before you begin the installation work and follow the
instructions given in them.
Requirements for installation
Ascertain that all the requirements for installation are met. This includes clearing and defining
the following important aspects during the planning phase (respect the references to elaborate
explanations about the respective topic in this manual):
1. Determine the power demand and the refrigeration requirements for the heating system to
be installed (→
2. Based on the performance features of Aquarea air-to-water heat pumps, select the model
suitable for the power demand (→
3. Based on the ambient conditions and the installation criteria for the various model types,
determine the optimum installation location for the indoor and outdoor unit or the mono-bloc
unit (→
4. Determine the requirements for the hydraulic connection of the devices (→
112). Always conform to the valid legal provisions.
p.
5. Determine the requirements for the electrical connection of the devices (→
p. 116). Always conform to the valid legal provisions.
6. Ensure that the accessories supplied are fully available, e.g. based on the following table.
Owing to the continuous development and improvement of the products, the kind and range
of the accessories supplied can, however, change at any time. So also always check the list
of the accessories supplied in the installation manual accompanying the device in question.
No.
a
b
c
d
e
f
g
h
i
j
k
l
m
1 Assembly accessory is to be provided on site.
Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
5.1 Refrigeration technology and performance criteria, p.
5.2 Installation criteria, p.
Component Qty..
Top mounting plate 1
Top mounting plate 1
Drain elbow 1
Packing 1
Bottom mounting plate 1
Bottom mounting plate 1
Screw 3
Rubber cap 8
Cable sleeve 2
Remote controller cover 1
Adjustable feet 4
Reducing adapter 1
Local remote controller 1
4.6 Functions and technical data, p.
97).
Description Bi-bloc systems
with All in One unit
for F generation
for J or H generation
for condensation hose ●
for drain elbow ●
for F generation
for J or H generation
to fasten the hydrokit to the
bottom mounting plate
for separate installation of the
●
remote controller
●
●
Installation
92).
27).
5.3 Hydraulics,
5.4 Electricals,
Mono-bloc
systems
with hydrokit
●
●
● ● ● ● ●
● ● ●
●
●
● ●
● ●
●
● ● ●
● ●
●
●
6
●
●
●
1
149