Control Panel And Display - Hitachi BD-SG100CJ Operating & Installation Instructions Manual

Button and Display Function
A
Power button
B
Start / Pause
C
Wash, Wash Dry
and Dry
D
Wash, Rinse,
Spin and Dry
E
Spin / Dry Level
F
Timer
G
Auto Self Clean
H
Door Lock
J
Lint fi lter
K
Dry fi lter
L
Hot
M
N Drain Trap
O
Display
P
Door Check
Q Overload(Dry)
R Open Tap

Control Panel and Display

L M
J K
D
Used to switch the unit ON/OFF.
If the unit is not started within 20 minutes, power will turn off automatically.
Used to start or pause the operation.
When the "Wash", "Wash Dry", "Dry" buttons are pressed, the selected course blinks.
When the " Start/Pause" button is pressed, only the selected course lights.
The "Wash", "Rinse", "Spin" and "Dry"settings can be changed.
This change may be impossible, depending on the course.
The spinning condition and the drying condition at drying can be adjusted
in two steps of "High" and "Low".
The operation end time can be set up to 3 to 24 hours later.
Automatically rinses off any dirt, etc. adhering to the outer side of the
drum or other locations that cannot be seen.
Prevents children from opening the door.
When set, " "and "Door Lock" are displayed.
Lights if lint fi lter is not set correctly.
Blinks if drying fi lter is clogged.
Lights or blinks when the temperature inside the drum is high.
Lights together with
Lights when storing water in the drain trap to prevent odor backflow in the drain outlet.
After operation starts, approximate remaining time and detergent quantity will be displayed.
Each time "Timer" is pressed, the reserve operation scheduled end time is displayed.
The notification contents generated during operation, etc. are displayed. (Example: C02, F01)
Blinks when the door is open or not closed completely when the laundry operation starts.
Lights when drying capacity is exceeded.
Lights when power on to help you to see if the tap is open.
Blinks when code such as "C01" or "C06" is displayed.
O
N P Q R
E F G
when set.
C
H
(P.30)
A
B
11