How To Install On Windows Server 2003 - NEC 1000BASE-T Manual

N8403-012 1000BASE-T Adapter (2ch)
4.5

How to install on Windows Server 2003

This section describes how to install the driver on WindowsServer2003
First, you update the onboard LAN driver and remove Intel
update the onboard LAN driver and remove Intel®PROSet" on page 60 for details.
Next, you attach N8403-012 to the CPU blade. See Chapter 2 "How to attach the adapter on
your server" on page 42 for details.
Then, install the N8403-012 driver by using the driver CD.
Here, you can install the driver by one of the following means. According to your administration/
operation style, select one.
To install from CPU blade,
→ see Section 4.5.2"How to install from CPU blade" on page62.
To install from TS client,
→ see Section 4.5.3 "How to install from TS client" on page63.
To install manually by using Device Manager,
→ see Section 4.5.4 "How to install manually by using Device Manager" on page 64.
To install from DPM(Ver.2.1/3.0),
→ see Section 4.5.5"How to install from DPM(Ver.2.1/3.0)" on page66.
To replace the adapter, first, you have to remove the driver,
then, reinstall it.
By removing the driver, the protocol information is also
deleted. Before you remove the driver, copy the network
information. Make the settings again after you have installed
it.
If you see the following messages when you start the system
after you have attached N8403-012, click [Cancel] to close
the dialog box.
[Found New Hardware Wizard] dialog box
®
PROSet. See Section 4.5.1 "How to
®
59
- -
English Edition(英語版)
®.