5 - 6
Modification of MAMMOMAT stand
MAMMOMAT with serial number lower than 5200 must be updated with new software.
1.
NOTE
Modification of MAMMOMAT generator
Replacing board D702
MAMMOMAT with serial number lower than 3242 must be updated with a new board
D702.
1.
2.
Fig. 6
Removal of generator front cover
3.
4.
5.
NOTE
Opdima?
Installation
Replace the existing software on board D801 with the V2.2 (or higher) software.
If upgrading from a version lower than V1.5, the AEC have to be
upgraded, see Update Instruction, UI 001/96.
Pry loose the plastic strips (1/Fig. 6), using a screwdriver or similar tool.
Remove the sixteen screws (2/Fig. 6) and remove the front cover (3/Fig. 6).
3
Remove the board D702 in Fig. 7 from the generator.
Install software V2.2 (or higher) on the new board D702.
Install the new board D702 Fig. 7 in the generator.
If upgrading from a version lower than V1.5, the AEC have to be
upgraded, see Update Instruction, UI 001/96.
Register 3
SPB7-230.033.10
Rev. 03
08.02
Installation
2
1
Page 6 of 26
Siemens-Elema AB
SPS-UD
5
5
5
Solna, Sweden