Table of Contents
Advertisement
Chapter 1
Getting Ready
· It usually takes within two minutes to complete a GPS search. If the GPS search does not
finish after three minutes or more, you may be in an environment where GPS signals
cannot be received. Select [Cancel] to stop the search, and then try again in another
location.
· If the GPS search does not finish after 10 minutes from the start of the search, the search is
stopped and the [Menu] screen is displayed.
· With the chronograph and interval functions, you can also select [GPS off] and perform
measurements. However, measurement items are limited at this time (
· When the GPS search is complete, the correct time is displayed.
Notes on GPS search
This device receives signals from multiple satellites and measures distance and pace.
When a signal is received from four or more satellites, the GPS search is complete and
the device is ready to measure.
You can take more stable measurements when the device is receiving a signal from six
or more satellites.
Searching may take some time when inside, in a tunnel, or in a location surrounded
by skyscrapers, because the signal from the satellite is interfered with or reflected
away from its target. You may not be able to complete the search if you are in an
environment where GPS signals cannot be received (
search outside with no obstructions overhead.
P.
23). Make sure you perform the
25
P.
21).
Number of
satellites
connected
Advertisement
Table of Contents
