Table of Contents
Advertisement
Chapter 3 Web GUI Functions
3.4 Configuration
Operation Item
Apply
Reset
Changing Network Information
1.
Specify each of the items under [Control Port Configuration] or [Maintenance Port Configuration].
Note
- Change the items under either [Control Port Configuration] or [Maintenance Port Configuration]. The
items of both ports cannot be changed at the same time.
- Set the Default Gateway only under either [Control Port Configuration] or [Maintenance Port
Configuration].
Display/Input Item
LAN Settings
MAC Address
IPv4 Address
Subnet Mask
Default Gateway
2.
Click the [Apply] button.
An execution confirmation dialog box appears.
Remarks
- To restore the currently set network information, click the [Reset] button instead of the [Apply] button.
3.
Click the [OK] button.
The current session is disconnected, and you are prompted on the screen to log in again.
The [Network Settings] screen displays the following items.
Display Item
LAN Settings
MAC Address
IPv4 Address
Subnet Mask
Default Gateway
Table 3.21 Operation Items on the [Network Settings] Screen
Change network information. For the procedure, see
Information."
Restore the currently set network information.
Table 3.22 Specifying Network Information
To enable the port, check the [Enable] check box.
The MAC address is displayed.
Specify an IP address in the xxx.xxx.xxx.xxx format. xxx is a value between 0
and 255.
Specify a subnet mask in the xxx.xxx.xxx.xxx format. xxx is a value between 0
and 255.
Specify the default gateway IP address in the xxx.xxx.xxx.xxx format. xxx is a
value between 0 and 255.
Table 3.23 Display Items on the [Network Settings] Screen
Indicates whether the port is enabled or disabled. If the port is enabled, the
[Enable] check box is checked.
Displays the MAC address.
Displays the IP address.
Displays the subnet mask.
Displays the default gateway IP address.
Description
Description
Details of Display
33
"Changing Network
C120-0091-02EN
Advertisement
Table of Contents
