Maintenance and Trouble Clearing
Replace RU Mounted on Wall
6.3
Replace RU Mounted on Wall
This procedure describes how to replace a RU that is mounted on a wall.
Prerequisites:
■ Loctite LB 8012 or equivalent lubricant applied to all bolts
■ 17 mm socket
■ 5/8 in. wrench
■ Philips screw driver
■ Power tools (optional)
■ Metric and SAE toolkit
Caution: All power and cabling must be disconnected from the RU
before starting this procedure.
Caution: The RU is heavy. Fujitsu recommends installing the RU
with a two-person team to avoid damage to the unit or injury to the
user.
Step 1
If necessary, attach hoisting equipment to eye bolts on top of the RU.
Step 2
Remove the two M10 x 40 bolts and washers from the front bottom of the RU.
Step 3
Remove the two M10 x 30 bolts and washers from the top of the RU.
·
Issue 1.1, May 2021
Release 1.0
Attention: Toute l'alimentation et le câblage doivent être
déconnectés de l'EF avant de commencer cette procédure.
Attention: Le RU est lourd. Fujitsu recommande de retirer l'EF d'une
équipe de deux personnes pour éviter d'endommager l'appareil ou
des blessures à l'utilisateur.
144
Fujitsu and Fujitsu Customer Use Only