Advertisement
176
Optical Connector Cleaning
LC End Surface Cleaning
Caution: Do not touch the end surfaces.
Attention: Ne touchez pas les surfaces d'extrémité.
✓
This task is complete.
Additional Instructions:
■ Clean again if the connector end surface is touched after the cleaning.
■ Do not use the same part of the cleaner more than once.
■ Do not wipe the boots of the connector for open circuit prevention.
■ Do not touch the ferrule part of the connector to the polyethylene cleaner guide.
■ Do not use a cleaner except to clean the ferrule.
Fujitsu and Fujitsu Customer Use Only
·
Issue 1.1, May 2021
Release 1.0
Advertisement
