Advertisement
Optical Connector Cleaning
End Surface Cleaning In LC
C.2
End Surface Cleaning In LC
This procedure describes how to clean the end surface in the LC.
Prerequisite:
■ Stick-type cleaner
Caution: Do not touch surface after cleaning. Scars form easily on
the connector's surface.
Caution: Do not use a cleaner except to clean the ferrule.
Step 1
Remove the connector protection cap.
Step 2
Insert the point of the cleaner straight into the ferrule side of the connector.
Note: It is not necessary to come in contact with the connector edges.
Step 3
Circle the ferrule seven times with the cleaner.
Step 4
After cleaning, promptly install in the connector or replace protection cap to protect from dust or debris.
✓
This task is complete.
Additional Instructions:
■ Clean again if the connector end surface is touched after the cleaning.
■ Do not use the same stick-type cleaner more than once.
■ Do not use a cleaner except to clean the ferrule.
·
Issue 1.1, May 2021
Release 1.0
Attention: Ne touchez pas la surface après le nettoyage. Les
cicatrices se forment facilement sur la surface du connecteur.
Attention: N'utilisez pas de nettoyant sauf pour nettoyer la virole.
177
Fujitsu and Fujitsu Customer Use Only
Advertisement
