Cleaning The Hot Water Shower; Cleaning The Accessories; Cleaning The Appliance - Silvercrest SEM 1100 B3 Operating Instructions Manual

Cleaning the hot water shower

Clean the hot water shower r after each use:
1) After you have prepared the espresso/cappuccino and removed the sieve
holder u, wipe the entire surface of the hot water shower r with a mois-
tened cloth to remove all powder residues .
2) Replace the sieve holder u without the espresso filters i o .
3) Place an empty cup under the sieve holder u and press the "Espresso"
button
rinsing out the remaining powder residue .
4) After about 20 seconds, press the "Espresso" button
switch the appliance off with the On/Off switch 1 .
5) Remove the sieve holder u again .

Cleaning the accessories

1) Clean the sieve holder u, the two espresso sieves i o, water tank 9, the
measuring spoon p and the drip grille q in warm water .
NoTE
► If you put detergent into the water, it may effect the taste of the espresso .
If the stains can only be removed with detergent, always rinse the items
afterwards with lots of clean water .
2) Dry all parts well .
3) The drip tray w is suitable for cleaning in the dishwasher . However, always
remove the red float from the drip tray w before cleaning:
–
To do this, remove the stoppers attached to the two retaining bars to the
side of the float .
–
Pull the float from the retaining bars .
–
Clean the float and stoppers .
–
After cleaning the drip tray w, push the cleaned float back onto the
retaining bars and replace the stoppers .

Cleaning the appliance

Clean the appliance with a moist cloth . If necessary, use a little detergent on the cloth .
Ensure that the appliance is completely dry before the next use .
■ 90 │ GB │ MT
3 down until it clicks in . Water flows out of the hot water shower r
3 again and
SEM 1100 B3