Troubleshooting - Silvercrest SEM 1100 B3 Operating Instructions Manual

19) Push in the "Steam" button
20) Hold a container under the milk frother 0 and slowly turn the steam control
button 7 to the position " + " as soon as the green heating-up control lamp 5
lights up .
21) After about 1 minute, close the steam control 7 (turn it in the direction of the
" - " as far as the stop), press the "Steam" button
the appliance .
NoTE
► If no button is pressed, the appliance turns off automatically after
30 minutes .

Troubleshooting

Malfunction
The espresso no longer
flows out .
The espresso drips over
the edges of the sieve
holder u, not from the
openings .
The espresso is cold .
The pump is unusually
noisy .
■ 92 │ GB │ MT
4 so that it clicks into place .
Cause
• The espresso powder is too
moist and/or compressed
too tightly .
• No water in the water tank 9 .
• The holes of the sieve holder
openings are blocked .
• The sieve holder u is not
correctly inserted .
• The sieve holder openings are
blocked .
• There are espresso powder
residues on the edges of the
sieve holder u .
• The appliance was not
preheated .
• The green heating-up control
lamp 5 has not yet glowed .
• The cups were not pre-warmed. • Pre-warm the cups.
• The water tank 9 is empty .
4 again and switch off
solution
• Re-prepare the espresso
without compressing the
powder as firmly; if neces-
sary, use new powder .
• Fill the water tank 9
with water .
• Clean the sieve holder u .
• Insert the sieve holder u
correctly .
• Clean the sieve holder u .
• Clean the espresso
powder residues from
the edges of the sieve
holder u .
• Preheat the appliance.
• Wait until the green
heating-up control
lamp 5 lights up .
• Fill the water tank 9
with water .
SEM 1100 B3