Table of Contents
Advertisement
Note: Wire gauge for the terminal block should be in the range from 12 to 24 AWG.
Note: The SPG-M041 can be powered by using the same DC source for power
redundancy feature.
A secondary power supply unit can be applied to IIoT gateway for power redundancy
to reduce network downtime as well as preventing chaos brought by power loss.
Note: A DC voltage range of 12 to 24 VDC must be applied between the V1+/V2+ and
the V1-/V2- terminal. The chassis ground screw terminal should be tied to the panel or
chassis ground.
3.3
Reset Button
The SPG-M041 provides a RESET push button, the main function of which is to reboot
and switch to driver installation.
Label
Interface
1
Reset
Chapter 3 – Gateway Setup and Configuration
Connector Type
Push button
Description
Reboot: Use a pointed object to press
reset button to reboot.
23
Advertisement
Table of Contents
