LG ACHH Series Manual page 37

The phenomena from main component failure
n EEV coil removal method of an Sub cooling circuit
Sub cooling EEV is composed as a figure below and can be separated into a coil and a body.
Body
Lead
Coil
n Coil removal method
Please hold the bottom part of a body tightly to not to be moved and take the coil out upwards.
In case where the coil is hooked to fix equipment so that it is difficult to take it out, please take
the coil out after getting off from the fix equipment by rotating the coil left and right.
In case of taking the coil out without holding the body part, the pipe can be banded due to the
excess force applying on the pipe. Therefore, please hold the body part tightly to not to be
The bottom
moved.
part of a body
n Coil installation method
Please hold the bottom part of a body tightly to not to be moved and insert the coil from the
top.
Please insert the fixed equipment of a coil to the groove of a body part correctly. (There are 4
grooves where the fixed equipment of a coil is inserted at the edges of a body part and it is
okay to insert any places out of 4 grooves.
Please be attention not to apply excess force to the wires or to twist with the body part.)
In case of inserting the coil without holding the body part, the pipe can be banded due to the
excess force applying on the pipe. Therefore, please hold the body part tightly to not to be
The
moved and then insert the coil.
bottom
part of a
body
- 37 -