Technical Maintenance; Safety Tests - GE Dash 3000 Operator's Manual

Maintenance

Technical Maintenance

Safety Tests

General
A-14
Message
BATTERY LOW
POWERING DOWN!
CHECK BATT STATUS
BATTERY ERROR
CHECK BATT STATUS
Diagrams, technical specifications and other relevant technical information can be
found in the service manual supplied with this equipment. Comply with the policies
of your institution's biomedical department and the preventive maintenance
recommendations in the service manual.
WARNING
—Failure on the part of all responsible individuals, hospitals or
institutions employing the use of this device to implement the
recommended maintenance schedule may cause equipment failure
and possible health hazards. The manufacturer does not in any
manner assume the responsibility for performing the recommended
maintenance schedule, unless an Equipment Maintenance
Agreement exists. The sole responsibility rests with the individuals,
hospitals or institutions utilizing the device.
General safety tests should be performed every 12 months. NBP and temperature
measuring devices should be tested every two years.
Safety tests may only be performed by qualified personnel not subject to
directives with respect to these tests.
Dash™ 3000/4000/5000
Solution
When this system WARNING sounds and
displays, only 10 minutes of battery run time
is remaining. Replace the battery or connect
the monitor to AC power.
When this system WARNING sounds and
displays, there is no battery run time left.
The monitor will power off unless connected
to AC power.
When this system message displays, the
battery is not functioning. Remove and
insert or replace the battery.
When this system WARNING sounds and
displays, the battery cannot be charged in
the monitor. Attempt charging in the external
battery charger or replace the battery.
When this system message displays, the
external charger failed to charge the battery.
Attempt charging the battery again or
replace the battery.
2000966-386D