Mitsubishi Electric MELSEC iQ-R Series User Manual page 102

(0) The following settings are applied by the master function parameter setting command.
■1st slave node
• Node address = 1, Message group = 4
• Connection type = Polling
• Input byte module = 1, Output byte module = 0
• Input word module = 0, Output word module = 0
• Input double-word module = 0, Output double-word module = 0
• Expected packet rate = 200ms (default)
• Watchdog timeout action = TIMEOUT (default)
• Production inhibit time = 10ms (default)
■2nd slave node
• Node address = 2, Message group = 4
• Connection type = Polling
• Input byte module = 0, Output byte module = 1
• Input word module = 0, Output word module = 0
• Input double-word module = 0, Output double-word module = 0
• Expected packet rate = 200ms (default)
• Watchdog timeout action = TIMEOUT (default)
• Production inhibit time = 10ms (default)
(78) The following settings are applied by the master function parameter setting command.
■3rd slave node
• Node address = 4, Message group = 1
• Connection type = Polling
• Input byte module = 8, Output byte module = 8
• Input word module = 0, Output word module = 0
• Input double-word module = 0, Output double-word module = 0
• Expected packet rate = 500ms
• Watchdog timeout action = AUTO DELETE
• Production inhibit time = 20ms
■4th slave node
• Node address = 3, Message group = 1
• Connection type = Bit strobe
• Input byte module = 4, Output byte module = 2
• Input word module = 0, Output word module = 0
• Input double-word module = 0, Output double-word module = 0
• Expected packet rate = 200ms (default)
• Watchdog timeout action = TIMEOUT (default)
• Production inhibit time = 10ms (default)
(127) The set parameters are written to 'Master function parameters' (U0\G472).
The master function parameter setting command is turned off.
APPX
100
Appendix 5 Setting the Parameter with a Program