2
PARAMETER SETTINGS
This chapter describes the parameter setting necessary for the RJ71DN91.
2.1
Setting Parameters
1.
Add the RJ71DN91 to the engineering tool.
[Navigation window] [Parameter] [Module Information] Right-click [Add New Module]
2.
"Basic Setting", "Applied Setting", and "Refresh Setting" are included in the module parameter. Select the settings from
the tree in the following window and configure them.
[Navigation window][Parameter][Module Information][RJ71DN91]
3.
Write the settings to the CPU module using the engineering tool.
[Online] [Write to PLC]
4.
The settings are reflected by resetting the CPU module or powering off and on the system.
2.2
Basic Settings
Set the parameter setting method of the RJ71DN91, the parameters for master function and slave function.
2 PARAMETER SETTINGS
2.1 Setting Parameters
2
37