Converting The Gas Type - LG FA415RMA Owner's Manual

CONVERTING THE
GAS TYPE
If the appliance is not already set up for the existing
type of gas, the appliance must be converted.
The conversion to a different type of gas must be
carried out by an authorised expert in accordance
with the applicable regulations.
The type of gas and pressure that was preset at the
factory are indicated on the insert of the instruction
manual.
In order to convert to a different type of gas, the
nozzles must be replaced and the low flame and
primary air may have to be adjusted.
WARNING
• TURN OFF THE POWER AND
THE SUPPLY OF GAS FROM
THE STOVE.
• REPLACE ALL PANELS AND
PARTS BEFORE OPERATING.
• RECONNECT ALL DEVICES
GROUNDING.
− FAILURE TO DO SO MAY
RESULT IN SERIOUS
PERSONAL INJURY, DEATH
OR IN A DISCHARGE
ELECTRIC.
CAUTION
• BE CAREFUL WHEN WORKING
ON THE HANDLING OF SHEET
METAL PARTS OF YOUR GAS
STOVE.
− SHARP EDGES CAN BE
PRESENT AND CAN BE CUT.

CONVERTING THE GAS TYPE

Hotplate burners
Replacing the nozzles
Proceed as follows:
• Remove the pan supports.
• Remove the burner lids (A) and burner sprayers (B)
from the burners (C).
A
B
C
• Remove the nozzle (D) and replace it with an
appropriate nozzle for the new type of gas (see
section "General nozzle table").
• Replace the gas label with the new label that was
supplied with the nozzle set.
D
• Place each burner sprayer (B) on the burner (C).
• Position the relevant burner cap (A) exactly on top
of the cup.
• Refit the pan supports.
A
B
C
35